Description
When one driver in your SVT-610HLF starts sounding thin or blown, the Ampeg 86-510-06 gets that cabinet back to full strength. Built by Eminence to Ampeg’s exact specification, it’s a direct swap rather than a generic substitute, so the cabinet’s voicing and output stay consistent with the other five drivers rather than fighting against a mismatched replacement.
- Nominal Size: 10 inches
- Impedance: 6 ohms
- Power Handling: 150 watts RMS / 300 watts peak
- Frequency Range: 40 Hz – 4 kHz
- Magnet Weight: 38 oz.
The magnet size and power rating give the driver enough headroom to keep low B strings tight and controlled at stage volume, while the extended frequency range up to 4 kHz keeps note definition and string attack from getting buried in the low end – exactly the balance the SVT series is known for.
This is strictly a cabinet-repair part: it’s sized and wired for the SVT-610HLF enclosure only, not a general-purpose PA or monitor woofer. If you’re touring or gigging with an SVT rig and one channel has gone quiet, dropping this in brings the cabinet back to matched output across all six drivers without any tonal compromise.
For techs and bass players who want the cabinet to sound like it did on day one, this is the part number to order – no guesswork on impedance or power handling, just a proper Ampeg-approved fix.
Reviews
There are no reviews yet.